€228 with coupon for Eachine Wizard X220S FPV Racer RC Drone Omnibus F4 5.8G 40CH 30A Dshot600 800TVL Flysky FS-i6X RTF – Mode 2 (Left Hand Throttle) from BANGGOOD
Eachine Wizard X220S FPV Racer RC Drone
Description:
Item | Specification |
Eachine Wizard X220S | Wheelbase: 220mm Frame arm: 4mm carbon fiber Weigh: 356g (without battery and camera mount) Take off weigh: 561g Package weigh: 1728g3K carbon fiber frame kit, 4mm thickness and 15mm width frame arms, the width is 10mm less than Eachine Wizard X220.Frame kit with camera angle scale and 30° camera mount for Runcam 3 Gopro session. Anti-vibration sponges to protect the racer frome crashing. |
Eachine MN2206 2300KV motor | KV: 2300 Max thrust: 1100G Length: 35MM NO.OF cell: 3-5S Diameter: 28MM Framework: 12N14P Shaft: 5mm Propeller: 5 inch Weight: 28g |
Eachine 30A BLHELI_S 4 in 1 ESC | Con. current: 30A Peak current (10S): 35A Input voltage: 2-5S BEC: 5V output Programming: YES Firmware: blheli_s Weight: 28g Size: 36*36MM |
Eachine 1179 800TVL CCD camera | Color: purple Sensor: CCDResolution(horizontal center): 800TVLShell size: 25mm*25mmWeight: 11gResolution: PAL: 1980H×1080 (2MP) Format: PALVideo output: 1.0Vp-p/75ΩAutomatic gain control: 0.25/0.50/0.75/1.00 adjustable, up to 55dB.AWB: ON/OFFExposure mode: electron exposureElectronic shutter: 1/50(1/60) – 1/100000 SGamma correction: 0.45/1.0Synchronization method: internal synchronizationLens: standard 2.8mm lens Working voltage: DC12V (Wide Voltage, measured that can be work in 5-13V)Workig current: 70mA (low power consumption)Workig temperature: -20℃–60℃Humidity: 0%~98% Strong backlighting effect |
5.8G 40CH 25MW 200mw 600MWswitchable transmitter | Video Format : NTSC/PAL Channel: 40CH Operating Temperature : -10~85℃ Connector: RP-SMA FemaleAntenna connector: RP-SMA Male |
Omnibus F4 V3 flight controller | Size: 36x36mmMount holes: 30.5×30.5mm STM32 F405 MCU, Runs Betaflight 3.0.1 firmware, could run faster loop time. Using F4 MCU controls OSD over SPI bus in DMA mode.OSD Configation has been included in Betaflight GUI. SBUS/PPM input (Pinheaders)6PWM output (1-4Pinheaders and Sh1.0 Plug, 5-6 as Pinheaders)With barometerSPI Sensor MPU6000 Included 128Mbit Flash, please always use BEC for the FC.Supported by BETAFLIGHT and dRonin |
Flysky FS-i6X 2.4GHz 10CH remote control | Channel: 6-10 (Default 6)Model Type: Fixed-Wing/Glider/HelicopterRF Range: 2.408-2.475GHzRF Power: < 20dBmRF Channel: 135Bandwidth: 500KHz2.4GHz System: AFHDS 2A / AFDHSModulation Type: GFSKStick Resolution 4096Low Voltage Warning: < 4.2VDSC port: PS/2 Port PPMChargeable: NoAntenna Length: 26mm (Dual Antenna)Weight: 392gPower: 6V DC 1.5AA*4Display: STNTransflective Display, LCD 128×64 Lattice, VA 73x39mm, LCD with white backlightSize: 174x89x190mmOn-line Update: YesColor: BlackCertificate: CE0678, FCC ID: N4ZFLYSKYI6X |
Flysky FS-A8S receiver | Channels: PPM 8CH Model type: Multi-rotorFrequency range: 2.408-2.475GHzBand width: 500KHzBand number: 135RX Sensitivity: -92 dBm 2.4GHz system: AFHDS 2AModulation type: GFSK DSC port: PPM Transfer method: FHSS Data output: 1.5mm*3 Pin PPMAntenna length: 26mm (Not including brass contacts)Input power supply: 4.0-8.4V Display method: LED No ground interference ( Transmitting and receiving 1 m from the ground): >300m Working current: 40mA Each channel data: depend on the transmitter Channel delay: <15mS Size: 20*14*5.3mmWeight: 1.2gCertificate: CE0678, FCCID: N45ZA8S00 |
1500mAH 4S 14.8V 75C battery | Capacity(mAh) : 1500Cells (s): 4Weight (g): 177Length(mm): 80Width(mm): 30Height(mm): 33Connector: XT60 |
Eachine 5051 3-blade propeller | Color: purple Quantity: 10 Pairs Mounting Hole: 5mm |
Eachine wizard X220S FPV drone english manual
Package included:
1 x Eachine Wizard X220S frame kit1 x Flysky FS-i6X remote control1 x Flysky FS-A8S receiver2 x 2206 2300KV motor CW 2 x 2206 2300KV motor CCW1 x Eachine 30A BLHELI_S 4 in 1 ESC1 x Omnibus F4 V3 flight controller1 x 800TVL camera 1 x 5.8G 40CH 25MW 200mw 600MW switchable VTX
10 x Eachine 5051 3-blade propeller purple CW10 x Eachine 5051 3-blade propeller purple CCW1 x 1500mAH 4S 14.8V 75C battery
1 x 30° Camera Mount(For Runcam3/Gopro session)1 x Charger1 x Pagoda antenna2 x Battery strap2 x Wrench
(Package doesn’t include Runcam 3, the Runcam 3 on the pictures for reference only.)